Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
Text excerpt from page 32 (click to view)
NO WATER SUPPLY
Is the water supply shut-off?
NO
Is the tap opened?
NO YES
Open the tap.
When you press both Wash button and Rinse buttons simultaneously, is the water level frequency below 40? NO Is the inlet valve filter clogged with impurity?
YES
Check the chamber (Air) and the tube clogged with impurity.
YES
Clean the filter.
NO
Is resistance of the inlet valve connector k? between 2 to 8
NO
Replace the inlet valve.
YES
Check the voltage between each terminal of inlet Valve is 220~240V. (Refer to 7-2 TEST MODE) Replace PWB assembly (Main).
NO
DETERGENT DOES NOT FLOW IN
Is water supplied?
NO YES
Refer to solution NO INLET
Wiring diagram
Are replaceptacles correctly connected to the terminals of inlet valve?
NO
Check the wiring on the dispenser. Put the detergent in the correct position
YES
SOFTENER MAIN PRE WASH WASH
Is detergent put in the correct compartment of the drawer?
